Your browser version is outdated. We recommend that you update your browser to the latest version.

Reading and saving Battery data and internal EEPROM chips

Connect SCL, SDA and GND pins of adapter to battery terminals.
Press READ button to read the Battery data.
LEDs “A” and “B” must change to green and you will see the data in Battery Data window. Then you can press SAVE button to save data in TXT format.

Note Battery must be placed in normal mode. 
To place battery in normal mode momentary apply the voltage about 10V to its terminals.
To find SCL and SDA terminals just try different combinations. These terminals are always next to each other. Avoid to connect positive terminal of the battery to adapter.

Reading and writing external EEPROM chips

Connect chip to adapter and choose its type in Chip menu.
Use the buttons to read, write and save the chip data.

Note: If the dump in Dump window is supported by the software, LED “D” will change to green. To read and write batteries with Integrated Flash  you must to connect battery to adapter as it's described in Reading and saving Battery data section.

 

Resetting chip

If you want to reset external EEPROM chip then connect it to adapter as described in Reading and writing external EEPROM chips section, if you want to reset battery with Integrated Flash then connect battery to adapter as it's described in Reading and saving Battery data and internal EEPROM chips section.

Choose chip in Chip menu.
Press READ button to read the chip. You will see the data in Dump window.
If the dump is supported,then LED “D” will change to green, FCC field and RESET  Enter FCC value and press RESET button. If reset is successful then corrected data in Dump window will change to blue.

Note: To reset  BQ20Zxx based battery press CALIBRATE button and enter the values.